STD Tuning Drivetrain 5 speed manual om617

5 speed manual om617

5 speed manual om617

 
  • 4 Vote(s) - 2.5 Average
 
Pages (2): Previous 1 2
NZScott
HX30W 73/44mm

398
04-01-2021, 03:15 AM #51
(03-31-2021, 04:03 AM)617cruizer Could this be done with 716.648 6speed trans? I think 716 has same bolt pattern as 717.411

I would say no, but then people were saying that about the 717.411 etc so...


Problems I could see is input shaft length on those, and the bellhousings are "thicker" looking with lesser of a flange on them than the older Getrags.


1978 300D, 373,000km... OM617.912 with a Holset HX30W, 7.5mm IP, 711.113 5 speed (project car, 7 years off the road and counting ;/)
1977 250 270,000km (parts car)
1977 300D (ex 280) 500,000km

1981 240D 498,000
1975 HJ45 ???,000
2001 2.8TD Rodeo 4x2 - 456,000 - DD




NZScott
04-01-2021, 03:15 AM #51

(03-31-2021, 04:03 AM)617cruizer Could this be done with 716.648 6speed trans? I think 716 has same bolt pattern as 717.411

I would say no, but then people were saying that about the 717.411 etc so...


Problems I could see is input shaft length on those, and the bellhousings are "thicker" looking with lesser of a flange on them than the older Getrags.



1978 300D, 373,000km... OM617.912 with a Holset HX30W, 7.5mm IP, 711.113 5 speed (project car, 7 years off the road and counting ;/)
1977 250 270,000km (parts car)
1977 300D (ex 280) 500,000km

1981 240D 498,000
1975 HJ45 ???,000
2001 2.8TD Rodeo 4x2 - 456,000 - DD




Pages (2): Previous 1 2
 
  • 4 Vote(s) - 2.5 Average
Users browsing this thread:
 3 Guest(s)
Users browsing this thread:
 3 Guest(s)