Bellhousing bolt thread and depth
Bellhousing bolt thread and depth
01-29-2013, 08:15 AM
#1
pic courtesy of dieselswapguys.com:
![[Image: 02_EngineCrank.jpg]](http://www.dieselswapguys.com/wp-content/uploads/2009/11/02_EngineCrank.jpg)
This post was last modified: 01-29-2013, 08:19 AM by Simpler=Better.
Newbie-read this: Cheap Tricks
617.952-220k-Getting built up
larsalan I guess I need to look at this stupid ass drip shit. What you have to like mess with those elements on the pump? What a fucking hassle. then use some wire to hold the throttle open or some shit?
Simpler=Better
01-29-2013, 08:15 AM #1Can someone measure the bolt thread/pitch, and hole depth on the back of a bare 617 block? Both my 617s are 500 miles away and I'm drawing up an adapter plate design. I'll share mine if you share yours
pic courtesy of dieselswapguys.com:
Newbie-read this: Cheap Tricks
617.952-220k-Getting built up
larsalan I guess I need to look at this stupid ass drip shit. What you have to like mess with those elements on the pump? What a fucking hassle. then use some wire to hold the throttle open or some shit?
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Users browsing this thread:
1 Guest(s)
1 Guest(s)