+- STD (https://www.superturbodiesel.com/std)
+-- Forum: Tuning (https://www.superturbodiesel.com/std/forumdisplay.php?fid=6)
+--- Forum: Engine (https://www.superturbodiesel.com/std/forumdisplay.php?fid=7)
+--- Thread: Where can I get H-Profile rods for the OM606 (/showthread.php?tid=2662)
Where can I get H-Profile rods for the OM606 - EDH_Performance - 05-29-2011
Hi,
I`m looking for upgrade my stock N/A rods, and some H-profile would be it
Does anybody know where to get them?
Best regards
RE: Where can I get H-Profile rods for the OM606 - EDH_Performance - 10-07-2011
bump
RE: Where can I get H-Profile rods for the OM606 - jeemu - 10-07-2011
Hi. Sten Parner on Sweden. Not over than 6000rpm
RE: Where can I get H-Profile rods for the OM606 - dieselmeken - 10-07-2011
(10-07-2011, 08:59 AM)jeemu Hi. Sten Parner on Sweden. Not over than 6000rpm
Lives 100 km fr.o.m. Me!
RE: Where can I get H-Profile rods for the OM606 - E300TSC - 10-07-2011
Why the 6000 RPM limit with the H beams? I thought they were good for 7000+ ???
RE: Where can I get H-Profile rods for the OM606 - jeemu - 10-08-2011
(10-07-2011, 09:16 PM)E300TSC Why the 6000 RPM limit with the H beams? I thought they were good for 7000+ ???26mm N/A piston pin and fat ass piston + high rpm is problems.
Also those Parner rods have little material on upper "eye". Made same plank as gasoline rods
RE: Where can I get H-Profile rods for the OM606 - EDH_Performance - 10-09-2011
(10-08-2011, 01:13 PM)jeemu(10-07-2011, 09:16 PM)E300TSC Why the 6000 RPM limit with the H beams? I thought they were good for 7000+ ???26mm N/A piston pin and fat ass piston + high rpm is problems.
Also those Parner rods have little material on upper "eye". Made same plank as gasoline rods
I thought the N\A piston was lighter than the turbo piston? How thick is the wrist pin on the turbo piston?
What will be the best combination rod\piston if you will go up to 7000+rpm?
I know the head+++ must be modificated
RE: Where can I get H-Profile rods for the OM606 - jeemu - 10-10-2011
(10-09-2011, 06:08 AM)EDH_PerformanceNot big difference on piston weight. Turbo have 28mm pin and it has 13mm inner hole, so its pretty stiff(10-08-2011, 01:13 PM)jeemu(10-07-2011, 09:16 PM)E300TSC Why the 6000 RPM limit with the H beams? I thought they were good for 7000+ ???26mm N/A piston pin and fat ass piston + high rpm is problems.
Also those Parner rods have little material on upper "eye". Made same plank as gasoline rods
I thought the N\A piston was lighter than the turbo piston? How thick is the wrist pin on the turbo piston?
What will be the best combination rod\piston if you will go up to 7000+rpm?
I know the head+++ must be modificated
.I d use original turbo parts.