+- STD (https://www.superturbodiesel.com/std)
+-- Forum: Tuning (https://www.superturbodiesel.com/std/forumdisplay.php?fid=6)
+--- Forum: Engine (https://www.superturbodiesel.com/std/forumdisplay.php?fid=7)
+--- Thread: OM606 with Dieselmekken IP (/showthread.php?tid=5015)
OM606 with Dieselmekken IP - ravenxm - 10-12-2013
https://www.facebook.com/photo.php?v=664928926874729
first of all it's an om606 engine with kkk k27 turbo
problem that i cant get no boost even aT 5k rpm i cant get over 1bar
3inch exaust
7.5mm elements
255 walbro pre pump
presure regulator
tubular manifold
i got a lot of smoke but no drive at all
RE: OM606 with Dieselmekken IP - MFSuper90 - 10-12-2013
Sounds like waste gate stuck open
RE: OM606 with Dieselmekken IP - ravenxm - 10-12-2013
(10-12-2013, 08:05 AM)MFSuper90 Sounds like waste gate stuck open
tnx check it now
RE: OM606 with Dieselmekken IP - Gasoil - 10-12-2013
In my Fiat Uno Turbo 1.6 I use a K27.2 from a Iveco 7,7 liter Bus, and months ago only boost at 1,0 bar, take off the turbo and was the wastegate, it not closed at 100% and exhaust gases not moves the turbine Ok. I clean it with WD40, and copper grease , hoping exhaust-intake manifold gasket from Argentina to see if it goes at 1,5 bar.
Lucky....
RE: OM606 with Dieselmekken IP - ravenxm - 10-12-2013
i have exterbal tial wastegate with 1.7bar spring