Engine replacement
Engine replacement
I know somebody who wants me to replace a 617 engine. Do I pull out the transmission with the engine or leave it in the car? Which way is easier?
And he wants the timing chain replaced. Anything I should know about replacing the chain?
Thanks for any advice.
when I did the swap on my dads 300d we left the trans in place and pulled the engine out the top!
(07-21-2010, 09:36 AM)willbhere4u when I did the swap on my dads 300d we left the trans in place and pulled the engine out the top!
(07-21-2010, 09:36 AM)willbhere4u when I did the swap on my dads 300d we left the trans in place and pulled the engine out the top!
I had a regular floor jack under the trans with a 2x4
It came out and went in pretty easy for me It took me two try's to get it lined up! The first time I had a wire get caught in there that I didn't see after that it was pretty simple!
Sounds good, thanks!
How much is a 1984 300TD engine with 279k miles on it worth?
And is that engine a direct swap into a 1985 300SD? What do I do with the SLS pump on the TD engine?
I would think about $500 if it runs good or at least that's as much as I would pay for one I bough my last engine in a trashed car for $400 and it was a recent rebuild
Quote:what do I do with the SLS pump?
Quote:what do I do with the SLS pump?
I wimped out and only pulled the engine out for the guy. He's having somebody else install it in his car. I ended up pulling the transmission out with the engine. It was my first time pulling a RWD engine/tranny, wasn't too hard. It was a little tricky keeping the engine away from both the firewall and the A/C condenser. And I had some trouble getting the flex disc to separate from the flange on the driveshaft. I had to knock the disc loose with a chisel.
Anybody need any 300TD parts?