anyone running open exhaust?
anyone running open exhaust?
There is no way to get the exhaust over there without causing ground clearance issues.
(11-04-2010, 06:17 AM)ForcedInduction There is no way to get the exhaust over there without causing ground clearance issues.
(11-04-2010, 06:17 AM)ForcedInduction There is no way to get the exhaust over there without causing ground clearance issues.
(11-04-2010, 07:40 PM)Actros617 Straight pipe and all you'll hear is droan!!
(11-04-2010, 07:40 PM)Actros617 Straight pipe and all you'll hear is droan!!
(11-04-2010, 10:22 PM)dropnosky I doubt it would matter in a truck like that, probably tons of road noise anywhere but off road!
(11-04-2010, 10:22 PM)dropnosky I doubt it would matter in a truck like that, probably tons of road noise anywhere but off road!
Forced is right about tips...
When I unbolted the exhaust from the down pipe on my 617 turbo the open pipe was facing towards the rear of the car (obviously) and it was crazy annoying. It resonated so bad the exhaust went back on two minutes later.
After that I cut that last section off the downpipe so that the end of the pipe points slightly back right at the ground and I have been driving like that for about three months and love it! I will finish it off coming out the passenger fender someday but for now its great. Sounds super throaty and NEVER resonates one bit.
thought I would share my inspiration
http://www.youtube.com/watch?v=v-rYFWD_yfs
thanks again for the info
Well yea stock height is fine. Try putting that in the rear or even try to behind the front right wheel on a very low w201.
AH put it out the RH fender like the 300slr
I sure wish, ill keep it clean and run it to the rear with a 3" turndown.
(11-05-2010, 07:17 PM)Captain America Forced is right about tips...
When I unbolted the exhaust from the down pipe on my 617 turbo the open pipe was facing towards the rear of the car (obviously) and it was crazy annoying. It resonated so bad the exhaust went back on two minutes later.
After that I cut that last section off the downpipe so that the end of the pipe points slightly back right at the ground and I have been driving like that for about three months and love it! I will finish it off coming out the passenger fender someday but for now its great. Sounds super throaty and NEVER resonates one bit.
(11-05-2010, 07:17 PM)Captain America Forced is right about tips...
When I unbolted the exhaust from the down pipe on my 617 turbo the open pipe was facing towards the rear of the car (obviously) and it was crazy annoying. It resonated so bad the exhaust went back on two minutes later.
After that I cut that last section off the downpipe so that the end of the pipe points slightly back right at the ground and I have been driving like that for about three months and love it! I will finish it off coming out the passenger fender someday but for now its great. Sounds super throaty and NEVER resonates one bit.