Block Heater on 300D
Block Heater on 300D
RCPro87
Unregistered
12-25-2010, 03:51 PM
#1
Thanks in advance
12-26-2010, 02:48 AM
#2
1990 Power Ram 50 V6 SOHC 24V 6g72
I can be wrong, don't take everything I say as verbatim, please fact-check first.
My posts are my personal opinions and thoughts, unless otherwise noted.
Check pass side of block for a brass lump with a spot for a cord to plug in. If all you find is a water plug with a 19mm hex, you'll need to put one in yourself.
1990 Power Ram 50 V6 SOHC 24V 6g72
I can be wrong, don't take everything I say as verbatim, please fact-check first.
My posts are my personal opinions and thoughts, unless otherwise noted.
12-26-2010, 10:34 PM
#3
ForcedInduction
12-26-2010, 10:34 PM
#3
Look for a plug to the upper rear of the starter. Of there is a blank thread-in plug you're out of luck for a block heater since they are near impossible to remove without major effort.
12-26-2010, 10:46 PM
#4
Have to take the manifolds off, prop the hood vertical, and give it enough force you think you'll crack the block, but they can be removed.
Probably easier to do it with the engine in the car instead of on a hoist like I did it...
1990 Power Ram 50 V6 SOHC 24V 6g72
I can be wrong, don't take everything I say as verbatim, please fact-check first.
My posts are my personal opinions and thoughts, unless otherwise noted.
10 foot cheater bar on a 3/4" drive breaker bar, 3/4" 6 point socket, and a chunk of 3/4 hex stock.
Have to take the manifolds off, prop the hood vertical, and give it enough force you think you'll crack the block, but they can be removed.
Probably easier to do it with the engine in the car instead of on a hoist like I did it...
1990 Power Ram 50 V6 SOHC 24V 6g72
I can be wrong, don't take everything I say as verbatim, please fact-check first.
My posts are my personal opinions and thoughts, unless otherwise noted.
Users browsing this thread:
3 Guest(s)
3 Guest(s)
Users browsing this thread:
3 Guest(s)
3 Guest(s)