Oil temp sender OM617A

STD Maintenance General Oil temp sender OM617A

View a Printable Version

0 Vote(s) - 0 Average

Syncro_G

0-60 in 29 sec

280

02-09-2011, 01:34 AM #1

I have a digital boost/pyro multi-gauge that has an oil temperature option. So it follows that I was thinking of adding a sender to my engine to take advantage of it.

Any recommendations on where to put the sender? I would think MB put a port somewhere for this purpose.

-------------
'84 G-Wagen turbodiesel
'75 240D 4-Speed

Syncro_G

02-09-2011, 01:34 AM #1

-------------
'84 G-Wagen turbodiesel
'75 240D 4-Speed

~~ForcedInduction~~

Banned

3,628

02-09-2011, 03:44 AM #2

Either the sump or the oil filter base sidewall. The sump will have an "actual temperature" but the filter housing will be after the oil has gone though the cooler.

ForcedInduction

02-09-2011, 03:44 AM #2

Either the sump or the oil filter base sidewall. The sump will have an "actual temperature" but the filter housing will be after the oil has gone though the cooler.

Syncro_G

0-60 in 29 sec

280

02-09-2011, 10:08 AM #3

By sump, you mean somewhere on the oil pan?
I'd much prefer that to a point right after the cooler

-------------
'84 G-Wagen turbodiesel
'75 240D 4-Speed

Syncro_G

02-09-2011, 10:08 AM #3

By sump, you mean somewhere on the oil pan?
I'd much prefer that to a point right after the cooler

-------------
'84 G-Wagen turbodiesel
'75 240D 4-Speed

~~ForcedInduction~~

Banned

3,628

02-09-2011, 11:26 AM #4

Yes. You could braze a plug into the size of the pan or use a sensor that replaces the drain plug.

ForcedInduction

02-09-2011, 11:26 AM #4

Yes. You could braze a plug into the size of the pan or use a sensor that replaces the drain plug.

View a Printable Version

0 Vote(s) - 0 Average

Users browsing this thread:
2 Guest(s)