would a similar kit work with I5 617 turbos?
would a similar kit work with I5 617 turbos?
02-09-2012, 12:24 PM
#1
(this ball-bearing kit is T5 Volvo specific) ...
This post was last modified: 02-09-2012, 12:24 PM by 300SD_KY.
http://www.atpturbo.com/mm5/merchant.mvc..._Code=VC30
(this ball-bearing kit is T5 Volvo specific) ...
02-09-2012, 01:35 PM
#2
1984 300D 4-speed ~200,000 miles
7.5mm M-pump, GT3582 turbo, F-Tune Performance intake/exhaust manifolds, A/A intercooler, 315 nozzles, Enlarged prechambers, Bosch 044 feed pump, Custom lightweight flywheel with 240mm clutch, Lowered, 17" AMG rims - 300 hp OM617 project
1985 300D 280,000 miles RIP
2001 F350 7.3 DP tuner, 4"exhaust, S&B intake
led-panzer
02-09-2012, 01:35 PM #2Probably would work pretty well, but I would spend $3,250 a little differently on my car
1984 300D 4-speed ~200,000 miles
7.5mm M-pump, GT3582 turbo, F-Tune Performance intake/exhaust manifolds, A/A intercooler, 315 nozzles, Enlarged prechambers, Bosch 044 feed pump, Custom lightweight flywheel with 240mm clutch, Lowered, 17" AMG rims - 300 hp OM617 project
1985 300D 280,000 miles RIP
2001 F350 7.3 DP tuner, 4"exhaust, S&B intake
02-09-2012, 03:02 PM
#3
1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
willbhere4u
02-09-2012, 03:02 PM #3You would need a custom exhaust/intake manifold
1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Users browsing this thread:
1 Guest(s)
1 Guest(s)