STD Tuning Drivetrain What's in your manual traaaaaaaans??

What's in your manual traaaaaaaans??

What's in your manual traaaaaaaans??

 
  • 0 Vote(s) - 0 Average
 
sassparilla_kid
diesel > all other fuels

1,618
10-08-2013, 08:22 PM #1
Okay so I know the manual calls for ATF in the manual trans, but when I did my swap on the w123 I used some synthetic 10w-30, and it seems to be much easier to shift now than when I first got it all going. That being said, I'm fairly certain my w115 probably has ATF in it, and while it isn't really difficult or anything to shift, it isn't slick like the w123 is.

Just curious if anybody else has had any similar experiences?

-1982 300D Turbo, 280k miles, ALDA apparently maxxed, fram 8038, 12 lbs boost, non-egr manifolds, W/M injection, 4 brake light mod, Gen II w126 front rotors/calipers, 4-speed swap
In the works: A/W IC, adjust pump, turbo rebuild (w/60 trim comp wheel)
-1980 300SD, 110k, project car. Goal is to get it lookin' like it did on the showroom floor (body and interior wise, not necessarily under the hood )
-1974 240D, FRESH PAINT!!!!!!
sassparilla_kid
10-08-2013, 08:22 PM #1

Okay so I know the manual calls for ATF in the manual trans, but when I did my swap on the w123 I used some synthetic 10w-30, and it seems to be much easier to shift now than when I first got it all going. That being said, I'm fairly certain my w115 probably has ATF in it, and while it isn't really difficult or anything to shift, it isn't slick like the w123 is.

Just curious if anybody else has had any similar experiences?


-1982 300D Turbo, 280k miles, ALDA apparently maxxed, fram 8038, 12 lbs boost, non-egr manifolds, W/M injection, 4 brake light mod, Gen II w126 front rotors/calipers, 4-speed swap
In the works: A/W IC, adjust pump, turbo rebuild (w/60 trim comp wheel)
-1980 300SD, 110k, project car. Goal is to get it lookin' like it did on the showroom floor (body and interior wise, not necessarily under the hood )
-1974 240D, FRESH PAINT!!!!!!

raysorenson
Superturbo

1,162
10-09-2013, 09:19 AM #2
To my knowledge, ATF is used for it's friction modifiers for the synchros. The lubricity difference between ATF and motor oil is probably negligible.

I've had experience with old ATF in a high mileage trans cause difficulty getting into gear. A fluid change helped significantly. Maybe putting motor oil in there would have also caused an improvement.
raysorenson
10-09-2013, 09:19 AM #2

To my knowledge, ATF is used for it's friction modifiers for the synchros. The lubricity difference between ATF and motor oil is probably negligible.

I've had experience with old ATF in a high mileage trans cause difficulty getting into gear. A fluid change helped significantly. Maybe putting motor oil in there would have also caused an improvement.

willbhere4u
Six in a row make her go!

2,507
10-09-2013, 10:04 AM #3
I use Royal Purple synthetic ATF

1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
willbhere4u
10-09-2013, 10:04 AM #3

I use Royal Purple synthetic ATF


1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running

tjts1
GT2256V

125
10-09-2013, 11:49 AM #4
Whatever ATF I could find in the garage.

[Image: 208104.png]
tjts1
10-09-2013, 11:49 AM #4

Whatever ATF I could find in the garage.


[Image: 208104.png]

Simpler=Better
PORTED HEAD

2,127
10-09-2013, 12:34 PM #5
My ranger has a Mazda MD05 manual tranny in it that is dying. It got Wolf's Head synthetic ATF last change.

Newbie-read this: Cheap Tricks
617.952-220k-Getting built up
larsalan I guess I need to look at this stupid ass drip shit. What you have to like mess with those elements on the pump? What a fucking hassle. then use some wire to hold the throttle open or some shit?
Simpler=Better
10-09-2013, 12:34 PM #5

My ranger has a Mazda MD05 manual tranny in it that is dying. It got Wolf's Head synthetic ATF last change.


Newbie-read this: Cheap Tricks
617.952-220k-Getting built up
larsalan I guess I need to look at this stupid ass drip shit. What you have to like mess with those elements on the pump? What a fucking hassle. then use some wire to hold the throttle open or some shit?

sassparilla_kid
diesel > all other fuels

1,618
10-09-2013, 01:23 PM #6
I might have to change the fluid in it sometime here in the near future, see if itsoothes things up a little

-1982 300D Turbo, 280k miles, ALDA apparently maxxed, fram 8038, 12 lbs boost, non-egr manifolds, W/M injection, 4 brake light mod, Gen II w126 front rotors/calipers, 4-speed swap
In the works: A/W IC, adjust pump, turbo rebuild (w/60 trim comp wheel)
-1980 300SD, 110k, project car. Goal is to get it lookin' like it did on the showroom floor (body and interior wise, not necessarily under the hood )
-1974 240D, FRESH PAINT!!!!!!
sassparilla_kid
10-09-2013, 01:23 PM #6

I might have to change the fluid in it sometime here in the near future, see if itsoothes things up a little


-1982 300D Turbo, 280k miles, ALDA apparently maxxed, fram 8038, 12 lbs boost, non-egr manifolds, W/M injection, 4 brake light mod, Gen II w126 front rotors/calipers, 4-speed swap
In the works: A/W IC, adjust pump, turbo rebuild (w/60 trim comp wheel)
-1980 300SD, 110k, project car. Goal is to get it lookin' like it did on the showroom floor (body and interior wise, not necessarily under the hood )
-1974 240D, FRESH PAINT!!!!!!

DeliveryValve
Superturbo

1,338
10-09-2013, 01:36 PM #7
I've filled with Mobil 1 5w30 before and regular ATF. Both worked just fine.

Gota love Mercedes Diesels!



.
DeliveryValve
10-09-2013, 01:36 PM #7

I've filled with Mobil 1 5w30 before and regular ATF. Both worked just fine.


Gota love Mercedes Diesels!



.

 
  • 0 Vote(s) - 0 Average
Users browsing this thread:
 5 Guest(s)
Users browsing this thread:
 5 Guest(s)