om606 standard turbo
om606 standard turbo
![[Image: alda001_zpsa114ca49.jpg]](http://s62.photobucket.com/user/a10ruk/media/300TD/alda001_zpsa114ca49.jpg.html)
10-09-2013, 04:07 PM
#3
The stock pump elements can flow enough.
You didn't specify if you are retaining electronic IP or going mechanical.
H.
Installed:
OM606/722.6, big IC, W220 brakes.
Planned:
DIY manifold, compound, 722.6 controller, built IP.
[i]Less rust.. [/i]
Standard everything, 200hp is easily achievable, I am in the same process, reduce parasitic losses ie egr valve delete and bigger intercooler.
The stock pump elements can flow enough.
You didn't specify if you are retaining electronic IP or going mechanical.
H.
Installed:
OM606/722.6, big IC, W220 brakes.
Planned:
DIY manifold, compound, 722.6 controller, built IP.
[i]Less rust.. [/i]
I'm going 603 pump. As its going non Mercedes vehicle.
Do I need to get the turbo played with or just change the vacuum waste gate to boost control.
Druk that's spot on did you make that or buy it? Do you sell them or were did you by the stuff from
Regards
Andy
10-09-2013, 04:33 PM
#5
(10-09-2013, 04:21 PM)boyt Druk that's spot on did you make that or buy it? Do you sell them or were did you by the stuff from
Regards
Andy
The pressure actuator I got from RADesigns.
www.TurboRebuild.co.uk
It's part number TB2804 and starts to open at 12psi. £49.99 GBP
The rod I had to shorten to suit and the mounting bracket, sliding box and rose joint connector I made myself.
The square end of the box is counter drilled to form a slight concave and that works against the inverted Nyloc nut and allows the box part to swing slightly to allow for the changing arc of the operating wastegate lever. The pushrod only works in the in/out plane and has no up/down movement so it would bind without some form of slack.
.
This post was last modified: 10-09-2013, 04:39 PM by Druk.
(10-09-2013, 04:21 PM)boyt Druk that's spot on did you make that or buy it? Do you sell them or were did you by the stuff from
Regards
Andy
The pressure actuator I got from RADesigns.
www.TurboRebuild.co.uk
It's part number TB2804 and starts to open at 12psi. £49.99 GBP
The rod I had to shorten to suit and the mounting bracket, sliding box and rose joint connector I made myself.
The square end of the box is counter drilled to form a slight concave and that works against the inverted Nyloc nut and allows the box part to swing slightly to allow for the changing arc of the operating wastegate lever. The pushrod only works in the in/out plane and has no up/down movement so it would bind without some form of slack.
.
10-09-2013, 04:45 PM
#6
H.
Installed:
OM606/722.6, big IC, W220 brakes.
Planned:
DIY manifold, compound, 722.6 controller, built IP.
[i]Less rust.. [/i]
Users browsing this thread:
5 Guest(s)
5 Guest(s)
Users browsing this thread:
5 Guest(s)
5 Guest(s)