2003 mercedes s500 4matic? whats it worth
2003 mercedes s500 4matic? whats it worth
My boss got it cheap and I'm trying to decide what to offer him for it
1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
willbhere4u
10-10-2013, 01:38 PM #1Its a 2003 s500 4matic it has 186k new axles and drive shaft but supposedly needs a transfer case the body is clean the interior needs a detailing the nav screen had a dime sized spot in the middle that doesn't work very annoying and the cup holder is fubar
My boss got it cheap and I'm trying to decide what to offer him for it
1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
willbhere4u
10-10-2013, 05:16 PM #2I bought it for 2k it makes lifter noise until it warms up and the transfer case or rear diff is make noise. But it runs out nice I'm a little nervous about the engine noise. I'm hoping it just a plugged lifter. I will run some sea foam through it and preform an oil change.
1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
willbhere4u
10-11-2013, 11:13 AM #4The transfer case is making bad noises I think its shot.
1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
willbhere4u
10-11-2013, 02:02 PM #5It clunk while accelerating or deceleration or turning and its A very loud sounds like a drive shaft about to fall off. I better get underneath it and check it the drive shafts where just replaced by the previous owner in the last 1k miles along with the axle shafts. maybe they where not tightened correctly? Any ways a used t/case with low miles can be had for around $600
1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
-1982 300D Turbo, 280k miles, ALDA apparently maxxed, fram 8038, 12 lbs boost, non-egr manifolds, W/M injection, 4 brake light mod, Gen II w126 front rotors/calipers, 4-speed swap
In the works: A/W IC, adjust pump, turbo rebuild (w/60 trim comp wheel)
-1980 300SD, 110k, project car. Goal is to get it lookin' like it did on the showroom floor (body and interior wise, not necessarily under the hood )
-1974 240D, FRESH PAINT!!!!!!
sassparilla_kid
10-11-2013, 02:35 PM #6You might need to consult the peach on this one
-1982 300D Turbo, 280k miles, ALDA apparently maxxed, fram 8038, 12 lbs boost, non-egr manifolds, W/M injection, 4 brake light mod, Gen II w126 front rotors/calipers, 4-speed swap
In the works: A/W IC, adjust pump, turbo rebuild (w/60 trim comp wheel)
-1980 300SD, 110k, project car. Goal is to get it lookin' like it did on the showroom floor (body and interior wise, not necessarily under the hood )
-1974 240D, FRESH PAINT!!!!!!
1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
willbhere4u
10-11-2013, 02:36 PM #7I will if I get stuck. I'm not a member over there yet
1987 300SDL 6spd manual om606.962 swap project
1985 300td euro 5spd wagon running
2 Guest(s)
2 Guest(s)