STD Maintenance General IP not working

IP not working

IP not working

 View a Printable Version
 
  • 0 Vote(s) - 0 Average
 
cjcosta
Find
TA 0301

51
10-29-2013, 01:23 PM #1
Reply
Reply
Hi everyone,
This weekend my w460 let me down in a Offroad raid.
OM617a MW IP
Start losing power, then completly dead. No fuel in the injector lines, just one is working.

Primary pump is working ok.

Any sugestion?

Best Regards
cjcosta
10-29-2013, 01:23 PM #1

Hi everyone,
This weekend my w460 let me down in a Offroad raid.
OM617a MW IP
Start losing power, then completly dead. No fuel in the injector lines, just one is working.

Primary pump is working ok.

Any sugestion?

Best Regards

Reply
Reply
Tito
Find
Holset

354
10-29-2013, 02:05 PM #2
Reply
Reply
How did you test check primary pump? Sounds like the problem is fuel supply. I doubt that all the plungers and barrels all failed at once. Unless you feed it gasoline.
Tito
10-29-2013, 02:05 PM #2

How did you test check primary pump? Sounds like the problem is fuel supply. I doubt that all the plungers and barrels all failed at once. Unless you feed it gasoline.

Reply
Reply
larsalan
Find
Superturbo

1,272
10-29-2013, 03:07 PM #3
Reply
Reply
I just had a failed lift pump the other day. It could pump with no resistance but, under back pressure it couldn't do anything.
This sounds like a fuel supply issue. Clogged lines, filters, dead lift pump. Did you try to open the injector lines and crank the starter?
Rusted out beat down 300d turbo 82' -- RIP
Nice body, tons of ridiculous mechanical issues - 300d turbo 82' /motor 85'
larsalan
10-29-2013, 03:07 PM #3

I just had a failed lift pump the other day. It could pump with no resistance but, under back pressure it couldn't do anything.
This sounds like a fuel supply issue. Clogged lines, filters, dead lift pump. Did you try to open the injector lines and crank the starter?

Rusted out beat down 300d turbo 82' -- RIP
Nice body, tons of ridiculous mechanical issues - 300d turbo 82' /motor 85'

Reply
Reply
cjcosta
Find
TA 0301

51
10-31-2013, 06:13 AM #4
Reply
Reply
Problem solved.

Got to go to a dieselshop. They found some dirt inside the pump.

I tried to start the engine and the lift pump was pumping a lot of diesel.

Thanks to all.
cjcosta
10-31-2013, 06:13 AM #4

Problem solved.

Got to go to a dieselshop. They found some dirt inside the pump.

I tried to start the engine and the lift pump was pumping a lot of diesel.

Thanks to all.

Reply
Reply
sassparilla_kid
Find
diesel > all other fuels

1,618
11-04-2013, 02:44 PM #5
Reply
Reply
Another thing that can cause problems is if the tank vent it plugged, the tank can get a vacuum in it and then the pump can't pump as hard as the tank is "sucking" and cause issues
-1982 300D Turbo, 280k miles, ALDA apparently maxxed, fram 8038, 12 lbs boost, non-egr manifolds, W/M injection, 4 brake light mod, Gen II w126 front rotors/calipers, 4-speed swap
In the works: A/W IC, adjust pump, turbo rebuild (w/60 trim comp wheel)
-1980 300SD, 110k, project car. Goal is to get it lookin' like it did on the showroom floor (body and interior wise, not necessarily under the hood )
-1974 240D, FRESH PAINT!!!!!!
sassparilla_kid
11-04-2013, 02:44 PM #5

Another thing that can cause problems is if the tank vent it plugged, the tank can get a vacuum in it and then the pump can't pump as hard as the tank is "sucking" and cause issues

-1982 300D Turbo, 280k miles, ALDA apparently maxxed, fram 8038, 12 lbs boost, non-egr manifolds, W/M injection, 4 brake light mod, Gen II w126 front rotors/calipers, 4-speed swap
In the works: A/W IC, adjust pump, turbo rebuild (w/60 trim comp wheel)
-1980 300SD, 110k, project car. Goal is to get it lookin' like it did on the showroom floor (body and interior wise, not necessarily under the hood )
-1974 240D, FRESH PAINT!!!!!!

Reply
Reply
 View a Printable Version
 
  • 0 Vote(s) - 0 Average
Users browsing this thread:
 3 Guest(s)
Users browsing this thread:
 3 Guest(s)