om605 strange noise from back injector
om605 strange noise from back injector
still the noise is there, replaced the leak off pipes aswell
when i hold my hand over that injector i can feel air pulsing at me, but doesnt seem to be leaking diesel, or if it is a very small amount.
heres a video to let yous hear the noise, any advice is welcome as its annoying me and likely not helping power or running
![[Image: th_20140625_193619_zps8a9f0214.jpg]](http://i157.photobucket.com/albums/t55/lilricky64/th_20140625_193619_zps8a9f0214.jpg)
any advice welcome and cheers
hello, my car has a strange hiss/tick from the back injector, ive tried tightening it, but was already very tight, took it out, clean the bottom face where it seals and what looks like a spacer, presume its the heat shield though, bout 2 or 3mm thick steel. I am surprised i didnt find a copper washer or seal of some sort though
still the noise is there, replaced the leak off pipes aswell
when i hold my hand over that injector i can feel air pulsing at me, but doesnt seem to be leaking diesel, or if it is a very small amount.
heres a video to let yous hear the noise, any advice is welcome as its annoying me and likely not helping power or running
any advice welcome and cheers
looks like the prechamber is loose.
just that.injector , heat shield, pre chamber, and nothing else. pre chamber seats over the head and is tight by a special ring wich uses a special tool. , unless the head had been faced , and there was the need for a spacer. usually .3 mm .6mm .8mm.
regards
FD,
Powered by tractor fuel
hy there ,
looks like the prechamber is loose. just that.
injector , heat shield, pre chamber, and nothing else. pre chamber seats over the head and is tight by a special ring wich uses a special tool. , unless the head had been faced , and there was the need for a spacer. usually .3 mm .6mm .8mm.
regards
FD,
Powered by tractor fuel
Try spraying some soapy water around the prechamber/injector to see if its leaking.
Can be hard to see on a 4-valve engine though.
You need a big splined special socket to remove the ring holding the prechamber in place.
Hi, It might be leaking compression between the head and the prechamber.
Try spraying some soapy water around the prechamber/injector to see if its leaking.
Can be hard to see on a 4-valve engine though.
You need a big splined special socket to remove the ring holding the prechamber in place.
is that the tool i need?
also is it a hard job to tighten up the pre chamber? or just a case of removing the injector, and tightening the splined ring?
Cheers
http://www.ebay.co.uk/itm/MERCEDES-BENZ-...4897.l4275
is that the tool i need?
also is it a hard job to tighten up the pre chamber? or just a case of removing the injector, and tightening the splined ring?
Cheers
whether is your choice, sealing bed must be clean, and the treads free from that "glue" . tightning torque is 40 n/m.
regards
FD,
Powered by tractor fuel
well, if sealing bed and treads are still ok, wich i think so, u can use loctite high temp , the black one, if u can get it somewhere, or cheaper and best exaust glue, that white stuff used to seal exaust piping.
whether is your choice, sealing bed must be clean, and the treads free from that "glue" . tightning torque is 40 n/m.
regards
FD,
Powered by tractor fuel
2 Guest(s)
2 Guest(s)