Turbo inlet housing
Turbo inlet housing
08-13-2015, 06:03 AM
#1
(photos are examples for reference)
Any suggestions would be appreciated.
Thanks
Mark
Attached Files
Image(s)1990 300GD SWB 463 Diesel W/ OM603A Turbo Diesel transplant
I am doing some modes on my 603 (adding an water/air intercooler and such) and need some room under the hood of my G300. The factory turbo inlet housing has the, (now plugged) pollution control unit built into the inlet housing. I would like to find one without this. This is a new turbo from the factory so I don't really want to replace the whole turbo just the inlet housing.
(photos are examples for reference)
Any suggestions would be appreciated.
Thanks
Mark
Attached Files
Image(s)1990 300GD SWB 463 Diesel W/ OM603A Turbo Diesel transplant
08-13-2015, 07:31 AM
#3
?
Installed:
OM606/722.6, big IC, W220 brakes.
Planned:
DIY manifold, compound, 722.6 controller, built IP.
[i]Less rust.. [/i]
http://www.superturbodiesel.com/std/show...p?tid=6679
?
Installed:
OM606/722.6, big IC, W220 brakes.
Planned:
DIY manifold, compound, 722.6 controller, built IP.
[i]Less rust.. [/i]
08-13-2015, 08:38 AM
#4
(08-13-2015, 07:23 AM)Hario Cut out blanking plate & drill holes from a bit of 6mm aluminium plate?
I could do this but there is also a piston like bladder that sinks down into the turbo inlet which I would need to figure out a way to close up as well if. I could just get the non-pollution control housing would be better. Thanks for the suggestion
1990 300GD SWB 463 Diesel W/ OM603A Turbo Diesel transplant
(08-13-2015, 07:23 AM)Hario Cut out blanking plate & drill holes from a bit of 6mm aluminium plate?
I could do this but there is also a piston like bladder that sinks down into the turbo inlet which I would need to figure out a way to close up as well if. I could just get the non-pollution control housing would be better. Thanks for the suggestion
1990 300GD SWB 463 Diesel W/ OM603A Turbo Diesel transplant
08-13-2015, 08:45 AM
#5
(08-13-2015, 07:31 AM)Hario http://www.superturbodiesel.com/std/show...p?tid=6679
?
This one is sold and is actually for a 617 motor don't know if it's going to be the same size turbo. Thanks
1990 300GD SWB 463 Diesel W/ OM603A Turbo Diesel transplant
(08-13-2015, 07:31 AM)Hario http://www.superturbodiesel.com/std/show...p?tid=6679
?
This one is sold and is actually for a 617 motor don't know if it's going to be the same size turbo. Thanks
1990 300GD SWB 463 Diesel W/ OM603A Turbo Diesel transplant
Users browsing this thread:
6 Guest(s)
6 Guest(s)
Users browsing this thread:
6 Guest(s)
6 Guest(s)