adapting to t3 flange
adapting to t3 flange
I am just wondering what people have done with converting the 3 bolt merc flange to a t3 flange? Does anyone else sell the adapters other than dieselpumpuk or do I have to get the 3 bolt flange machined up myself? I don't really fancy paying £160+ on a manifold adapter really...
Thanks
Hi,
I am just wondering what people have done with converting the 3 bolt merc flange to a t3 flange? Does anyone else sell the adapters other than dieselpumpuk or do I have to get the 3 bolt flange machined up myself? I don't really fancy paying £160+ on a manifold adapter really...
Thanks
87 300SDL OM606 swapped HE351VE 722.633 swapped, Crower cams, KM valvesprings
76 300TD custom lots of stuff
06 Mercedes CL65 AMG 619 WHP, http://TurboTims.com
I just welded a cast 45 to T3 flange. Actually had cast elbow from 603 mani.
87 300SDL OM606 swapped HE351VE 722.633 swapped, Crower cams, KM valvesprings
76 300TD custom lots of stuff
06 Mercedes CL65 AMG 619 WHP, http://TurboTims.com
I bought an adapter from Hario in UK on here. PM him about your needs. He's a nice guy and will help you. He made a header. Look at his thread to see. You may want to go his route. Depending on your HP needs, a simple adapter on the oe manifold may not suffice. I went the adapter route because my HP requirement is only 250-300.
50harleyrider
05-18-2016, 06:42 AM #3Lewis,
I bought an adapter from Hario in UK on here. PM him about your needs. He's a nice guy and will help you. He made a header. Look at his thread to see. You may want to go his route. Depending on your HP needs, a simple adapter on the oe manifold may not suffice. I went the adapter route because my HP requirement is only 250-300.
At the moment I am only aiming for 250hp if possible. I don't want to play around with the IP just yet. I will send Hario a PM now though. Thanks
I have seen a cast 45 degree elbow to a t3 flange on another thread, I'm not sure if it was yours TurboTim? That was one way I was thinking of going with it.
At the moment I am only aiming for 250hp if possible. I don't want to play around with the IP just yet. I will send Hario a PM now though. Thanks
2 Guest(s)
2 Guest(s)