OM605 engine and gearbox
OM605 engine and gearbox
I have:
OM605 engine (with 138,000 miles on it)
Manual Gearbox from a C250 W202... I will check the codes on the gearbox
C250 turbo
C250 inlet (one on the engine is broken)
Gear shifter linkage from a W202 C250
I would like £300GBP for this engine and gearbox set up. I can grab some pics if you need them.
I also have a W124 250D OM602 that I planned to use the pump, engine mount arms, wiring harness, vacuum pump, etc. from too... engine runs good tho so I will sell complete too if you are interested.
I can ship this stuff wherever you need, it just may take a few weeks for me to get it all wrapped up and ready to ship. I am based in Banbridge in Northern Ireland.
Thanks
Stefan
I have an OM605 turbo diesel engine and gearbox here that I bought for my old 190. However, I have since scrapped the car and no longer need the engine.
I have:
OM605 engine (with 138,000 miles on it)
Manual Gearbox from a C250 W202... I will check the codes on the gearbox
C250 turbo
C250 inlet (one on the engine is broken)
Gear shifter linkage from a W202 C250
I would like £300GBP for this engine and gearbox set up. I can grab some pics if you need them.
I also have a W124 250D OM602 that I planned to use the pump, engine mount arms, wiring harness, vacuum pump, etc. from too... engine runs good tho so I will sell complete too if you are interested.
I can ship this stuff wherever you need, it just may take a few weeks for me to get it all wrapped up and ready to ship. I am based in Banbridge in Northern Ireland.
Thanks
Stefan
-1982 300D Turbo, 280k miles, ALDA apparently maxxed, fram 8038, 12 lbs boost, non-egr manifolds, W/M injection, 4 brake light mod, Gen II w126 front rotors/calipers, 4-speed swap
In the works: A/W IC, adjust pump, turbo rebuild (w/60 trim comp wheel)
-1980 300SD, 110k, project car. Goal is to get it lookin' like it did on the showroom floor (body and interior wise, not necessarily under the hood )
-1974 240D, FRESH PAINT!!!!!!
sassparilla_kid
05-06-2018, 12:42 PM #3Dang I'd be interested but shipping to California would probably be killer!
-1982 300D Turbo, 280k miles, ALDA apparently maxxed, fram 8038, 12 lbs boost, non-egr manifolds, W/M injection, 4 brake light mod, Gen II w126 front rotors/calipers, 4-speed swap
In the works: A/W IC, adjust pump, turbo rebuild (w/60 trim comp wheel)
-1980 300SD, 110k, project car. Goal is to get it lookin' like it did on the showroom floor (body and interior wise, not necessarily under the hood )
-1974 240D, FRESH PAINT!!!!!!
2 Guest(s)
2 Guest(s)