Question about OM617 pump drive
Question about OM617 pump drive
Well im making a few mods to my OM617 that im dropping into my Jeep Cherokee. One is i needed to make a delete for the factory vacuum pump. Well because im not good at leaving well enough alone i took the injection pump "dampener?" Drive apart only realize its 2 pieces and sprung. Can i lock it into place? Or do i need to reassemble it to make the engine work? And if i do have to reassemble it do i have to take the timing cover off and gear out to do it?
1978 300D, 373,000km... OM617.912 with a Holset HX30W, 7.5mm IP, 711.113 5 speed (project car, 7 years off the road and counting ;/)
1977 250 270,000km (parts car)
1977 300D (ex 280) 500,000km
1981 240D 498,000
1975 HJ45 ???,000
2001 2.8TD Rodeo 4x2 - 456,000 - DD
That's the "timing device" and needs to be put back together if you want your injection timing to advance properly. I've never had one apart so can't help you but think it's pretty simple as long as you didn't lose any bits!
1978 300D, 373,000km... OM617.912 with a Holset HX30W, 7.5mm IP, 711.113 5 speed (project car, 7 years off the road and counting ;/)
1977 250 270,000km (parts car)
1977 300D (ex 280) 500,000km
1981 240D 498,000
1975 HJ45 ???,000
2001 2.8TD Rodeo 4x2 - 456,000 - DD
1978 300D, 373,000km... OM617.912 with a Holset HX30W, 7.5mm IP, 711.113 5 speed (project car, 7 years off the road and counting ;/)
1977 250 270,000km (parts car)
1977 300D (ex 280) 500,000km
1981 240D 498,000
1975 HJ45 ???,000
2001 2.8TD Rodeo 4x2 - 456,000 - DD
Good luck, others might have tips
1978 300D, 373,000km... OM617.912 with a Holset HX30W, 7.5mm IP, 711.113 5 speed (project car, 7 years off the road and counting ;/)
1977 250 270,000km (parts car)
1977 300D (ex 280) 500,000km
1981 240D 498,000
1975 HJ45 ???,000
2001 2.8TD Rodeo 4x2 - 456,000 - DD
3 Guest(s)
3 Guest(s)