Start up procedure after IP install
Start up procedure after IP install
I’m going to install a Dieselmeken EDC 7.5 mm pump into my 0M606 later this week. I want to know what is the start up procedure after the pump is installed and all the fuel lines are reconnected? Is there any priming or other such as making sure the fuel filter is topped off? Please advise.
Then crank in 15-30 second bursts. Keep topping up the battery. Once you see fluid at an injector, tighten that one up. Once you have four tightened up you can safely do them all. It will start pretty quickly after that.
When doing any fuel work, it saves a lot of time to clamp the fuel feed and return hoses. That keeps the fuel much closer and results in a lot less cranking.
Crack open all six fuel line fittings at the injectors. Just enough so that they can leak.
Then crank in 15-30 second bursts. Keep topping up the battery. Once you see fluid at an injector, tighten that one up. Once you have four tightened up you can safely do them all. It will start pretty quickly after that.
When doing any fuel work, it saves a lot of time to clamp the fuel feed and return hoses. That keeps the fuel much closer and results in a lot less cranking.
emoynier Do you need a Baum 606 Injector socket, to crack the injectors?Best to have the correct socket for the nut on the hard line to keep from rounding off the nut. Sometimes they are hard to loosen. There are a couple brands making these, available on E-bay.
emoynier Do you need a Baum 606 Injector socket, to crack the injectors?Best to have the correct socket for the nut on the hard line to keep from rounding off the nut. Sometimes they are hard to loosen. There are a couple brands making these, available on E-bay.
M pumps do not need line breaks... it doesn't go any faster.
If car is using own lift pump, this one is also able to suck from thank even with very small air leaks. Nevertheless filling filter with diesel will help. Besides that is cranking. 45 sec should be enough.
Since is a first start .... one fella at ignition is desirable....
FD,
Powered by tractor fuel
hy guys,
M pumps do not need line breaks... it doesn't go any faster.
If car is using own lift pump, this one is also able to suck from thank even with very small air leaks. Nevertheless filling filter with diesel will help. Besides that is cranking. 45 sec should be enough.
Since is a first start .... one fella at ignition is desirable....
FD,
Powered by tractor fuel
2 Guest(s)
2 Guest(s)