Hx35 oil feed restrictor

STD Tuning Engine Hx35 oil feed restrictor

View a Printable Version

0 Vote(s) - 0 Average

Reapo

Naturally-aspirated

2

10-21-2020, 06:35 PM #1

Hi guys, wondering do I need to fit a restrictor to my oil feed for holset hx35, fitting it to an om605. Thanks James

Reapo

10-21-2020, 06:35 PM #1

Hi guys, wondering do I need to fit a restrictor to my oil feed for holset hx35, fitting it to an om605. Thanks James

Simon B

K26-2

36

10-22-2020, 11:41 AM #2

No, but you do need to fit the biggest drain that you can.

Simon B

10-22-2020, 11:41 AM #2

No, but you do need to fit the biggest drain that you can.

Reapo

Naturally-aspirated

2

10-23-2020, 12:18 AM #3

Thanks for the response, yes I have gone for a drain from a cummins dodge ram which is 19mm.

Reapo

10-23-2020, 12:18 AM #3

Thanks for the response, yes I have gone for a drain from a cummins dodge ram which is 19mm.

50harleyrider

GTA2359VK

397

10-28-2020, 05:30 AM #4

When I was doing my 606 conversion including a VNT Garrett turbo, all the material and advice I could dig up at the time indicated the largest drain I could fit. So far, so good. If you have a hydraulic hose shop nearby, don't hesitate to use them. Good drainage= less oil into the boost air. You'll still get some but the goal is to minimize it via good drainage and turbo bearings.

This post was last modified: 10-28-2020, 05:30 AM by 50harleyrider.

50harleyrider

10-28-2020, 05:30 AM #4

View a Printable Version

0 Vote(s) - 0 Average

Users browsing this thread:
4 Guest(s)