Merge Collector 5-1

STD Tuning Engine Merge Collector 5-1

Merge Collector 5-1

View a Printable Version

1 Vote(s) - 1 Average

miguelrocha

Naturally-aspirated

9

02-22-2021, 02:10 PM #1

Can someone find me a template for A4 paper to make the right cuts to make a Merge 5-1? Thanks

I'm using 48.3 tube

miguelrocha

02-22-2021, 02:10 PM #1

Can someone find me a template for A4 paper to make the right cuts to make a Merge 5-1? Thanks

I'm using 48.3 tube

Simon B

K26-2

36

02-22-2021, 02:34 PM #2

I doubt you will find such a thing, what you really need is a jig and a band saw.

Simon B

02-22-2021, 02:34 PM #2

I doubt you will find such a thing, what you really need is a jig and a band saw.

miguelrocha

Naturally-aspirated

9

02-22-2021, 06:42 PM #3

The band saw is missing: /
I only have an angle grinder

miguelrocha

02-22-2021, 06:42 PM #3

The band saw is missing: /
I only have an angle grinder

Mallinman

GT2256V

101

03-01-2021, 02:51 PM #4

Just do what I did. Buy two lengths of pipe and just keep cutting till you get it right. There are online template calculators that you can put all ur details into and then print off the paper to wrap round the pipe to get the cuts. I used one and it got me just about there. Did save me quite a bit of time. 5-1 is so much harder than even tube numbers

Mitsubishi L200 manual om605
7.5mm Bosch 044 fed pump
Borgwarner S200

Mallinman

03-01-2021, 02:51 PM #4

Mitsubishi L200 manual om605
7.5mm Bosch 044 fed pump
Borgwarner S200

View a Printable Version

1 Vote(s) - 1 Average

Users browsing this thread:
4 Guest(s)