EDC Pump to chassis multipin

STD Tuning Engine EDC Pump to chassis multipin

View a Printable Version

0 Vote(s) - 0 Average

Photomonkey

Naturally-aspirated

3

11-23-2021, 09:42 PM #1

Of all my questionable posts, I am by far most embarrassed by this one...

How do I remove/reconnect this connector? The end of the EDC pump to w210 chassis connector.

I can't remember if there's a trick to it; it's been long enough that I can't remember; I don't want to break it... yada yada yada

Thanks!

...

Photomonkey

11-23-2021, 09:42 PM #1

barrote

Superturbo

1,627

11-24-2021, 04:18 AM #2

Just plug it in... in the right position, the slide lock may have to be forced or slide open to lock.
Remove by sliding the lock open.
Its questionable , but as everithing in life one need to learn...

FD,
Powered by tractor fuel

barrote

11-24-2021, 04:18 AM #2

FD,
Powered by tractor fuel

AlanMcR

mind - blown

400

11-30-2021, 12:48 AM #3

As barrote said. The latch can be seen to be free when the slide lock is pushed inwards. Though it can take a pretty firm push/pull to get it together or apart.

AlanMcR

11-30-2021, 12:48 AM #3

As barrote said. The latch can be seen to be free when the slide lock is pushed inwards. Though it can take a pretty firm push/pull to get it together or apart.

View a Printable Version

0 Vote(s) - 0 Average

Users browsing this thread:
3 Guest(s)