STD Tuning Engine Alda Installed Height

Alda Installed Height

Alda Installed Height

 
  • 0 Vote(s) - 0 Average
 
zeeman
Holset

444
03-06-2015, 01:10 PM #1
Anyone know the installed height of the OM 617 Turbo ALDA valve. This is the shim pack under the housing when it is screwed on to the pump.
zeeman
03-06-2015, 01:10 PM #1

Anyone know the installed height of the OM 617 Turbo ALDA valve. This is the shim pack under the housing when it is screwed on to the pump.

Captain America
Boostin' & Roostin'

2,221
03-10-2015, 02:49 AM #2
Just take it off and trash it


1982 300D Turbo ... 3,6xxlbs, No fan, No AC, Hood Stack, No ALDA, No rear bumper and stuffed front, A/W Intercooled, Injectors by Greezer and HUGE Pre-Chambers with help from OM616 & Simpler=Better, Fuel Cranked up, 60 Trim Compressor wheel, EGT, EMP, Boost 50" Rigid Radius bar on roof Aux tank for a total of 48 Gal Of Diesel! Odyssey PC-1750 Battery in trunk, 27"x8.5"/R14 Maxxis BigHorn Mud Terrains, In June '14 issue of Off Road Mag

AX15 Jeep Trans swap in progress....

Captain America
03-10-2015, 02:49 AM #2

Just take it off and trash it



1982 300D Turbo ... 3,6xxlbs, No fan, No AC, Hood Stack, No ALDA, No rear bumper and stuffed front, A/W Intercooled, Injectors by Greezer and HUGE Pre-Chambers with help from OM616 & Simpler=Better, Fuel Cranked up, 60 Trim Compressor wheel, EGT, EMP, Boost 50" Rigid Radius bar on roof Aux tank for a total of 48 Gal Of Diesel! Odyssey PC-1750 Battery in trunk, 27"x8.5"/R14 Maxxis BigHorn Mud Terrains, In June '14 issue of Off Road Mag

AX15 Jeep Trans swap in progress....

bricktron
'77 240D

174
03-11-2015, 12:03 PM #3
since it requires adjustment later on anyway, i would just pick a middle height and then be ready to move the screw.


english red rat rod 1977 240D, OM617.952 burning B99.9, iron 4-speed & 2.88 diff, 195/60/R14 on alloys, 5mph bumpers, battery in the trunk, 25mm swaybar, 4x ECE H4 lamps, double brake lamps, deleted sunroof, export zoll & california blue plates




bricktron
03-11-2015, 12:03 PM #3

since it requires adjustment later on anyway, i would just pick a middle height and then be ready to move the screw.



english red rat rod 1977 240D, OM617.952 burning B99.9, iron 4-speed & 2.88 diff, 195/60/R14 on alloys, 5mph bumpers, battery in the trunk, 25mm swaybar, 4x ECE H4 lamps, double brake lamps, deleted sunroof, export zoll & california blue plates




 
  • 0 Vote(s) - 0 Average
Users browsing this thread:
 1 Guest(s)
Users browsing this thread:
 1 Guest(s)