+- STD (https://www.superturbodiesel.com/std)
+-- Forum: Tuning (https://www.superturbodiesel.com/std/forumdisplay.php?fid=6)
+--- Forum: Engine (https://www.superturbodiesel.com/std/forumdisplay.php?fid=7)
+--- Thread: Cam regrinding on OM606 need help about lash?c (/showthread.php?tid=6474)
Cam regrinding on OM606 need help about lash?c - TurboTim - 04-28-2015
Crower is regrinding my cams right now and we are looking at getting 30 degrees more duration but does anyone know how much lash the lifters can make up or has anyone had to shim under the buckets?
RE: Cam regrinding on OM606 need help about lash?c - raysorenson - 04-29-2015
Sorry I'm of zero help here, but how much of the base circle is getting ground off? Just curious.
Cat cams sells .5mm valve stem caps.
RE: Cam regrinding on OM606 need help about lash?c - TurboTim - 04-29-2015
I think they were going to do .030
RE: Cam regrinding on OM606 need help about lash?c - F.R.A.S - 05-01-2015
Look at the facebook site in my signature.
RE: Cam regrinding on OM606 need help about lash?c - TurboTim - 05-01-2015
How long you used them? What about the weight?
RE: Cam regrinding on OM606 need help about lash?c - TurboTim - 05-01-2015
How thick are they?
RE: Cam regrinding on OM606 need help about lash?c - TurboTim - 05-01-2015
and last question.....How much?
RE: Cam regrinding on OM606 need help about lash?c - F.R.A.S - 05-01-2015
Thickness is depending on how thick you need them
Send me a PM about the rest
RE: Cam regrinding on OM606 need help about lash?c - mytmousemalibu - 05-04-2015
Glad Crower is able to help you out! I'm anxious to see your results when finished, I may have to do the same. And lash caps were what I was thinking to compensate whats been taken off base circle also.
RE: Cam regrinding on OM606 need help about lash?c - whipplem104 - 05-07-2015
It occurred to me that you could have the cam plate milled down to make up for the smaller base circles. You would have to make sure the timing chain tensioner could pull up the slack in the timing chain or remove a link and also either adjust the timing gear for the cam timing or adjust the profile on the cams to get it back where you want. It might not be enough to make a lot of difference but it would retard the timing. You would have to degree the cams to find out.
RE: Cam regrinding on OM606 need help about lash?c - barrote - 05-11-2015
hello there,
how much lift are u doing with this regrind? if is just a 1mm the hyd tappets shoud cover for it and the timing staying the same? right?