+- STD (https://www.superturbodiesel.com/std)
+-- Forum: Tuning (https://www.superturbodiesel.com/std/forumdisplay.php?fid=6)
+--- Forum: Engine (https://www.superturbodiesel.com/std/forumdisplay.php?fid=7)
+--- Thread: Schwitzer S200 om603 (/showthread.php?tid=6929)
Schwitzer S200 om603 - Xzitenz - 12-18-2015
Was wondering how this would work. I actually allready have the turbo installed, but still stock pump. Planning on a 7.5.
Compressor in: 53mm
Turbine ex: 65mm
T3 twin inlet
Came off a 7.4 deutz straight 6.
Would this work or is it shit?
RE: Schwitzer S200 om603 - MFSuper90 - 12-18-2015
That would be very similar to a holset hx35, only a little smaller. How big is the exhaust housing? Most engines that size have exhaust housings much too large for our application.
RE: Schwitzer S200 om603 - Xzitenz - 12-18-2015
I have no idea about the size, there isnt any stamps or anything. But it looks pretty big. The deutz it was ment for was a 200kva generator set. Might as well just get a hx35 or something then.
RE: Schwitzer S200 om603 - MFSuper90 - 12-18-2015
I wouldn't get rid of it yet. A smaller housing, say a .91, .88, or .83 should make that turbo a good match for a 603. Just make sure your turbine clears the housing! Several people around me have machined out the inside of the housing to fit a smaller housing to a larger turbine.
RE: Schwitzer S200 om603 - Xzitenz - 12-18-2015
Okay thanks, maybe I should give it a go!