+- STD (https://www.superturbodiesel.com/std)
+-- Forum: Tuning (https://www.superturbodiesel.com/std/forumdisplay.php?fid=6)
+--- Forum: Engine (https://www.superturbodiesel.com/std/forumdisplay.php?fid=7)
+--- Thread: OM606 Boat engine (/showthread.php?tid=7124)
OM606 Boat engine - Carlos69 - 03-28-2016
Hi All
first post on here and looking for a little help.
I have built a marine engine with 250hp took off electronic pump and replace with mech one but finding it hard to get throttle cable from boat controls to fit to meck pump. any one done this??
Thanks
RE: OM606 Boat engine - zeeman - 03-29-2016
(03-28-2016, 01:11 AM)Carlos69 Hi All
first post on here and looking for a little help.
I have built a marine engine with 250hp took off electronic pump and replace with mech one but finding it hard to get throttle cable from boat controls to fit to meck pump. any one done this??
Thanks
On my Jeep conversions, I make a plate to go were the fuel heater was in the head and make a bracket to hold the cable and then put a carb style ball on the IP linkage. Just snap on the cable. Also made a bracket for a stiffer spring.
RE: OM606 Boat engine - Carlos69 - 06-12-2016
Hi
I dont think i could bend the 33c cable in that spot they are not flexible like car ones but will give it a go
thanks for info
RE: OM606 Boat engine - baldur - 06-12-2016
Maybe use the linkage from an OM603 with the jointed rods and the rocker arm mounted at the rear of the block.
RE: OM606 Boat engine - TurboTim - 06-12-2016
Maybe have your cable pull a smaller more flexible cable.
RE: OM606 Boat engine - atypicalguy - 06-12-2016
(03-29-2016, 01:32 AM)zeeman(03-28-2016, 01:11 AM)Carlos69 Hi All
first post on here and looking for a little help.
I have built a marine engine with 250hp took off electronic pump and replace with mech one but finding it hard to get throttle cable from boat controls to fit to meck pump. any one done this??
Thanks
On my Jeep conversions, I make a plate to go were the fuel heater was in the head and make a bracket to hold the cable and then put a carb style ball on the IP linkage. Just snap on the cable. Also made a bracket for a stiffer spring.
Zeeman you could probably sell a few of those brackets and cables. I would buy one. The dieselpumpuk guys have one that they want a lot of money for, and almost as much again for shipping.