STD
Turbo Suggestion for a OM602962 - Printable Version

+- STD (https://www.superturbodiesel.com/std)
+-- Forum: Tuning (https://www.superturbodiesel.com/std/forumdisplay.php?fid=6)
+--- Forum: Engine (https://www.superturbodiesel.com/std/forumdisplay.php?fid=7)
+--- Thread: Turbo Suggestion for a OM602962 (/showthread.php?tid=913)



Turbo Suggestion for a OM602962 - alesbm - 12-05-2009

Turbo Suggestion for a OM602962

Anyone know a good turbo replacement for a OM602962 for a 250D turbo, it can be a vnt...

I m looking for Garett 2256V or someting similar,

The engine is in mercedes benz G end using for extrem offroad
end i need more torque in low renge


RE: Turbo Suggestion for a OM602962 - ForcedInduction - 12-05-2009

GT1852V, GT2052V, GTA2056V (Liberty), GT2256V (Sprinter) and GT2359V (E320 CDI) would be good matches. The 59mm compressor would be large until a modified injection pump is installed.

If off roading and extreme low end torque is your primary goal, a GT1852V or GT2052V would be able to produce 15psi at 2000rpm without surge.

The GTA2056V and GT2256V would allow much higher boost from 2500rpm to redline.


RE: Turbo Suggestion for a OM602962 - alesbm - 12-06-2009

I prefere GT2052V (WV 2.5TDI V6 or GT2256V (Sprinter) because
is easyer to founded in Europa.


How to modified injection pump end the iniecion with thease new turbo???


The torque from 2500rpm to redline is OK.


RE: Turbo Suggestion for a OM602962 - winmutt - 12-07-2009

2052 is too small. The 2359 is fairly common over there as is the 2059 etc.


RE: Turbo Suggestion for a OM602962 - ForcedInduction - 12-07-2009

(12-07-2009, 01:55 PM)winmutt 2052 is too small.

Not for a 602. At 15psi it will be right at the max compressor speed at engine redline (at sea level).

A 2359 on a 602 for "extreme offroad" would be surging until mid-rpms.


RE: Turbo Suggestion for a OM602962 - alesbm - 12-09-2009

I found a MB 320CDI turbocharger GT2056V, I hope that this is OK


RE: Turbo Suggestion for a OM602962 - ForcedInduction - 12-09-2009

If its a 2008+ model, its got a rear facing turbine inlet.

   


RE: Turbo Suggestion for a OM602962 - nazim - 12-23-2009

(12-09-2009, 03:48 AM)alesbm I found a MB 320CDI turbocharger GT2056V, I hope that this is OK

Hello,

How is the result on your new turbo?
I also have OM602, 2.9 liter. I'm looking after a turbo to get more power at low rpm.

Please let me know if the application is successfull or not.

Thanks,
Nazim