5 speed manual om617
5 speed manual om617
04-01-2021, 03:15 AM
#51
(03-31-2021, 04:03 AM)617cruizer Could this be done with 716.648 6speed trans? I think 716 has same bolt pattern as 717.411
I would say no, but then people were saying that about the 717.411 etc so...
Problems I could see is input shaft length on those, and the bellhousings are "thicker" looking with lesser of a flange on them than the older Getrags.
1978 300D, 373,000km... OM617.912 with a Holset HX30W, 7.5mm IP, 711.113 5 speed (project car, 7 years off the road and counting ;/)
1977 250 270,000km (parts car)
1977 300D (ex 280) 500,000km
1981 240D 498,000
1975 HJ45 ???,000
2001 2.8TD Rodeo 4x2 - 456,000 - DD
(03-31-2021, 04:03 AM)617cruizer Could this be done with 716.648 6speed trans? I think 716 has same bolt pattern as 717.411
I would say no, but then people were saying that about the 717.411 etc so...
Problems I could see is input shaft length on those, and the bellhousings are "thicker" looking with lesser of a flange on them than the older Getrags.
1978 300D, 373,000km... OM617.912 with a Holset HX30W, 7.5mm IP, 711.113 5 speed (project car, 7 years off the road and counting ;/)
1977 250 270,000km (parts car)
1977 300D (ex 280) 500,000km
1981 240D 498,000
1975 HJ45 ???,000
2001 2.8TD Rodeo 4x2 - 456,000 - DD
Users browsing this thread:
26 Guest(s)
26 Guest(s)
Users browsing this thread:
26 Guest(s)
26 Guest(s)