Oil temp sender question.
Oil temp sender question.
08-08-2010, 09:21 PM
#2
However, it will be very low to the ground. Nearly every 616/617 I see in the junkyards has a side of the plug head scraped off. I wouldn't do it without getting the belly pan first.
This post was last modified: 08-08-2010, 09:22 PM by ForcedInduction.
ForcedInduction
08-08-2010, 09:21 PM
#2
Yes, as long as it has a way to seal on the oil pan. An o-ring or crush washer.
However, it will be very low to the ground. Nearly every 616/617 I see in the junkyards has a side of the plug head scraped off. I wouldn't do it without getting the belly pan first.
08-09-2010, 01:54 AM
#3
This post was last modified: 08-09-2010, 01:55 AM by Actros617.
1984 300SD 4 Dr Diesel Sports Car (ARGUS) (Mine)
1987 300SDL Cruiser STOCK (My fathers)
Oil plug scrapped?? I dont see any scrapings on my drain bolt, the plug resides at the rear of the oil pan i dont see possible ways for it to scrape unless your trying to rally jump with your Mercedes
1984 300SD 4 Dr Diesel Sports Car (ARGUS) (Mine)
1987 300SDL Cruiser STOCK (My fathers)
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Users browsing this thread:
1 Guest(s)
1 Guest(s)