turbo oil feed

STD Tuning Engine turbo oil feed

turbo oil feed

turbo oil feed

View a Printable Version

0 Vote(s) - 0 Average

bjarni97

Naturally-aspirated

15

09-07-2014, 11:15 AM #1

When you guys turbo a non turbo om 603. Where do you get a clean oil feed.
Is the oil at the oil pressure sensor pre filter or post filter.

bjarni97

09-07-2014, 11:15 AM #1

When you guys turbo a non turbo om 603. Where do you get a clean oil feed.
Is the oil at the oil pressure sensor pre filter or post filter.

baldur

Fast

509

09-07-2014, 04:51 PM #2

There's a port on the back of the cylinder head that takes a banjo bolt, 18x1.5mm if I recall correctly.
You can also fit a tee inline with the oil pressure switch on the oil filter housing.

Baldur Gislason

baldur

09-07-2014, 04:51 PM #2

There's a port on the back of the cylinder head that takes a banjo bolt, 18x1.5mm if I recall correctly.
You can also fit a tee inline with the oil pressure switch on the oil filter housing.

Baldur Gislason

Max

Turbinaaa

87

09-07-2014, 05:59 PM #3

Om60- 1/ 2 / 3 have a Port at the back of the Cylinderhead.

Size is M10 x 1

I use it for Oiltemperature at my Turbo-OM602 Wink

Wink

______________________________________________________________
93´ W124 300TDT -> OM606.962 / RS 203 Dieselmeken 7,5mm 210cc / KKK K14 / Stock Transmission / 2,65 ASD
89´ 190D 2.5 Turbo -> OM605.960 / Dieselmeken 7,5mm 180cc / Holset HX30 Super / 716. 654 6-Speed / 2,87 Rear Axle

Max

09-07-2014, 05:59 PM #3

Om60- 1/ 2 / 3 have a Port at the back of the Cylinderhead.

Size is M10 x 1

I use it for Oiltemperature at my Turbo-OM602 Wink

______________________________________________________________
93´ W124 300TDT -> OM606.962 / RS 203 Dieselmeken 7,5mm 210cc / KKK K14 / Stock Transmission / 2,65 ASD
89´ 190D 2.5 Turbo -> OM605.960 / Dieselmeken 7,5mm 180cc / Holset HX30 Super / 716. 654 6-Speed / 2,87 Rear Axle

bjarni97

Naturally-aspirated

15

09-09-2014, 04:45 AM #4

Thank you. Big Grin

Big Grin

bjarni97

09-09-2014, 04:45 AM #4

Thank you. Big Grin

View a Printable Version

0 Vote(s) - 0 Average

Users browsing this thread:
2 Guest(s)

Users browsing this thread:
2 Guest(s)