Threaded glow plug connector for OM606
Threaded glow plug connector for OM606
87 300SDL OM606 swapped HE351VE 722.633 swapped, Crower cams, KM valvesprings
76 300TD custom lots of stuff
06 Mercedes CL65 AMG 619 WHP, http://TurboTims.com
Does anyone know if they make a threaded glow plug for the OM606. I just want to use my existing harness from my OM603 motor to power my glow plugs but the OM606 has a push on harness.
87 300SDL OM606 swapped HE351VE 722.633 swapped, Crower cams, KM valvesprings
76 300TD custom lots of stuff
06 Mercedes CL65 AMG 619 WHP, http://TurboTims.com
pin is A003 545 26 26 and housing A019 545 54 28.
Buy 1 first to check they are the correct dia. My 606.962 had different dia push-ons than the earlier 606.910
Would be easier and certainly cheaper to change the end on the cables to suit the existing push-on glo-plugs.
pin is A003 545 26 26 and housing A019 545 54 28.
Buy 1 first to check they are the correct dia. My 606.962 had different dia push-ons than the earlier 606.910
Installed:
OM606/722.6, big IC, W220 brakes.
Planned:
DIY manifold, compound, 722.6 controller, built IP.
[i]Less rust.. [/i]
I bought replacement NKG?bosch or something glow plugs 'to suit OM606.962' and they were threadded so i just cut off the push on connectors and soldered/crimped on electrical ring terminals and used a nut either side, M5 IIRC.
Installed:
OM606/722.6, big IC, W220 brakes.
Planned:
DIY manifold, compound, 722.6 controller, built IP.
[i]Less rust.. [/i]
87 300SDL OM606 swapped HE351VE 722.633 swapped, Crower cams, KM valvesprings
76 300TD custom lots of stuff
06 Mercedes CL65 AMG 619 WHP, http://TurboTims.com
I need that PN! That would be perfect.
87 300SDL OM606 swapped HE351VE 722.633 swapped, Crower cams, KM valvesprings
76 300TD custom lots of stuff
06 Mercedes CL65 AMG 619 WHP, http://TurboTims.com
2 Guest(s)
2 Guest(s)