Om617 what this bolt does?
Om617 what this bolt does?
04-25-2015, 04:28 PM
#1
![[Image: 20150425_165059_zpstpag40qa.jpg]](http://i278.photobucket.com/albums/kk105/carlitosgy6/20150425_165059_zpstpag40qa.jpg)
carlitosgy6
04-25-2015, 04:28 PM #1What hold this bolt? I need a reinforcement bracket to hold a sanden 508 so i want to know if i can remove that bolt without causing something to fall inside the engine, let me know if i can use it, seems big
04-25-2015, 04:46 PM
#2
I believe that bolt holds a guide for the timing chain. I'll look for a diagram to post.
04-25-2015, 05:43 PM
#4
(04-25-2015, 04:46 PM)Torkey I believe that bolt holds a guide for the timing chain. I'll look for a diagram to post.
Upper large hex bolt gives access to the oil galley plug, the low bolt holds the timing chain guide and access to the lower oil galley plug.
I would come off the stock A/C mounting bosses on the block.
(04-25-2015, 04:46 PM)Torkey I believe that bolt holds a guide for the timing chain. I'll look for a diagram to post.
Upper large hex bolt gives access to the oil galley plug, the low bolt holds the timing chain guide and access to the lower oil galley plug.
I would come off the stock A/C mounting bosses on the block.
04-25-2015, 07:44 PM
#5
carlitosgy6
04-25-2015, 07:44 PM #5I was thinking coming from the stock bolt location bit they are too far from the place the compressor goes, the compressor will be pulled by the belt plus will vibrate a little, thats why I want to do an extra bracket from that point, thanks everyone
04-26-2015, 01:47 AM
#6
look if it lines up with the ones on the backside
looks like one of 3bolts that holds the injection pump.
look if it lines up with the ones on the backside
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Users browsing this thread:
1 Guest(s)
1 Guest(s)