Manual to automatic conversion

STD Tuning Drivetrain Manual to automatic conversion

View a Printable Version

0 Vote(s) - 0 Average

Oddi16

Naturally-aspirated

3

10-04-2015, 01:35 PM #1

hey i am going to buy a w201 with om603 engine. it is now manual, but i am thinking about putting in an automatic gearbox. what do i need to get this working?

Oddi16

10-04-2015, 01:35 PM #1

hey i am going to buy a w201 with om603 engine. it is now manual, but i am thinking about putting in an automatic gearbox. what do i need to get this working?

Tito

Holset

354

10-04-2015, 03:47 PM #2

The auto trans, starterring / flexplate, torque converter (and the corresponding bolts), shorter driveshaft, gearbox mount, gear selector with linkage, bowden linkage, some vacuum lines, P/N and R switches should be connected, kick down switch.

You could choose to just dump the clutch pedal, or swap pedal cluster.

Oh, and I think there's some kind of vacuum regulating valve controlled bij the throttle lever on the pump, to control shift firmness. You'll need that too.

Tito

10-04-2015, 03:47 PM #2

Druk

Holset

297

10-05-2015, 01:54 AM #3

Radiator with cooler and gearbox oil cooling pipes. Possibly inlet manifold with associated bellcranks to suit gearbox pull cable linkage? Speedo cable? Definitely the pump control for the gearbox vacuum modulator.

More bother than it's worth imho.

Druk

10-05-2015, 01:54 AM #3

Hario'

C300TD Wagon (W202)

894

10-08-2015, 07:36 AM #4

Fit a 722.6 w/Ole controller? Then you can throw away all the vacuum balls

Installed:
OM606/722.6, big IC, W220 brakes.
Planned:
DIY manifold, compound, 722.6 controller, built IP.
[i]Less rust.. [/i]

Hario'

10-08-2015, 07:36 AM #4

Fit a 722.6 w/Ole controller? Then you can throw away all the vacuum balls

Installed:
OM606/722.6, big IC, W220 brakes.
Planned:
DIY manifold, compound, 722.6 controller, built IP.
[i]Less rust.. [/i]

View a Printable Version

0 Vote(s) - 0 Average

Users browsing this thread:
3 Guest(s)