Thoughts about om605 with om602 2,9 crank

STD Tuning Engine Thoughts about om605 with om602 2,9 crank

Thoughts about om605 with om602 2,9 crank

Thoughts about om605 with om602 2,9 crank

View a Printable Version

0 Vote(s) - 0 Average

EvoPeter

GT2256V

161

11-12-2015, 04:10 AM #1

Whats your thoughts about stroking a om605 with a crank from a om602 2,9?

I read somewhere that it would make it a 2,7L.

Good or Bad?

-----------------------------------------------------------------------------------------------------------------------------
Mercedes 190 -92, om605 Stroker 2.75L, Dieselmeken 7,5mm (160cc) EDC with Baldur DSL1 ECU, Garrett GTX3576R A/R 1.06 without WG, SMF, 716.661 (SG-S370/6) Gearbox

EvoPeter

11-12-2015, 04:10 AM #1

Whats your thoughts about stroking a om605 with a crank from a om602 2,9?

I read somewhere that it would make it a 2,7L.

Good or Bad?

-----------------------------------------------------------------------------------------------------------------------------
Mercedes 190 -92, om605 Stroker 2.75L, Dieselmeken 7,5mm (160cc) EDC with Baldur DSL1 ECU, Garrett GTX3576R A/R 1.06 without WG, SMF, 716.661 (SG-S370/6) Gearbox

barrote

Superturbo

1,627

11-12-2015, 04:59 AM #2

Hy ,
i´m doing a similar thing,
it does work , however u need diff tipe rod, the piston stick out 2.5 mm , is too much and then u have to balange the set ...
but it does not give u 2.7lts, the 2.9 crank is 91.3mm stroke .

FD,
Powered by tractor fuel

barrote

11-12-2015, 04:59 AM #2

Hy ,
i´m doing a similar thing,
it does work , however u need diff tipe rod, the piston stick out 2.5 mm , is too much and then u have to balange the set ...
but it does not give u 2.7lts, the 2.9 crank is 91.3mm stroke .

FD,
Powered by tractor fuel

View a Printable Version

0 Vote(s) - 0 Average

Users browsing this thread:
1 Guest(s)

Users browsing this thread:
1 Guest(s)