Oil Pressure Gauge tap
Oil Pressure Gauge tap
05-30-2016, 05:10 AM
#4
(05-26-2016, 01:50 PM)matfield I had thought about there but wasn't sure if I'd get a good reading. Thats the one with the 6mm allen keyed blanking screw, towards the bottom of the filter housing?
Yes, that's the one! I've used it for pressure and works fine.
1992 W201 190D 2.0L and 1971 W108 280SE with OM606, electronic pump and 6 speed manual gearbox.
(05-26-2016, 01:50 PM)matfield I had thought about there but wasn't sure if I'd get a good reading. Thats the one with the 6mm allen keyed blanking screw, towards the bottom of the filter housing?
Yes, that's the one! I've used it for pressure and works fine.
1992 W201 190D 2.0L and 1971 W108 280SE with OM606, electronic pump and 6 speed manual gearbox.
06-07-2016, 01:37 PM
#7
Hoss, when I ordered the gauge, there wasn't an M12x1.5 adapter in the Kit. There was an M12x1 and M10x1 but not the one I need.
Om, quick update. The thread inside that bung is actually M12x1.5. I bought a ⅛ 27 NPT tap and managed to pull the head off the threaded section on the bung, so now have to order an M12x1.5 to ⅛ 27 NPT adapter.
Hoss, when I ordered the gauge, there wasn't an M12x1.5 adapter in the Kit. There was an M12x1 and M10x1 but not the one I need.
06-20-2016, 04:29 PM
#8
No adaptors needed, just get the right sender. http://www.ebay.co.uk/itm/Oil-Pressure-0...5b20a3d03c
Users browsing this thread:
2 Guest(s)
2 Guest(s)
Users browsing this thread:
2 Guest(s)
2 Guest(s)