OM606 300HP TURBO

STD Tuning Engine OM606 300HP TURBO

OM606 300HP TURBO

OM606 300HP TURBO

View a Printable Version

1 Vote(s) - 5 Average

Val7

K26-2

25

03-07-2017, 12:42 AM #1

Looking for the best turbo for 300hp om606.962, ive read that hx35 is good choice but havnt really seen a solid answer.

Val7

03-07-2017, 12:42 AM #1

Looking for the best turbo for 300hp om606.962, ive read that hx35 is good choice but havnt really seen a solid answer.

hents99

GT2256V

157

03-07-2017, 01:45 AM #2

HX35 is bit laggy for 300hp target. HY35 has smaller turbine housing and should be more comfortable to drive than with HX35.

------------------------------------------------------------------------
www.elbe.ee - MB performance parts.

hents99

03-07-2017, 01:45 AM #2

HX35 is bit laggy for 300hp target. HY35 has smaller turbine housing and should be more comfortable to drive than with HX35.

------------------------------------------------------------------------
www.elbe.ee - MB performance parts.

barrote

Superturbo

1,627

03-07-2017, 02:40 AM #3

In the 606, the HX35 WG with dual scroll #12 turbine housing works great. As mentioned above is a bit laggy , but that will happen with any turbo of the same size Compressor and turbine(core inertia). This was based on a mod i made, pump is a 7.5 150cc, engine gave 320HP at whells.
In my opinion the HX is a cheap solution, and for the 606 the #10/11 turbine housing would be perfect, the compressor swapped by a billet wheel, (those mamba or kinugawa etc) slightly bigguer so that the housing has to be machined to mach perfectly.
BUT IF budget is not a problema go for KKK EFR or GTX series, or a pair one in each 3 cylinders...
regards

FD,
Powered by tractor fuel

barrote

03-07-2017, 02:40 AM #3

In the 606, the HX35 WG with dual scroll #12 turbine housing works great. As mentioned above is a bit laggy , but that will happen with any turbo of the same size Compressor and turbine(core inertia). This was based on a mod i made, pump is a 7.5 150cc, engine gave 320HP at whells.
In my opinion the HX is a cheap solution, and for the 606 the #10/11 turbine housing would be perfect, the compressor swapped by a billet wheel, (those mamba or kinugawa etc) slightly bigguer so that the housing has to be machined to mach perfectly.
BUT IF budget is not a problema go for KKK EFR or GTX series, or a pair one in each 3 cylinders...
regards

FD,
Powered by tractor fuel

hents99

GT2256V

157

03-07-2017, 04:17 AM #4

Here's hx35 on om606 g wagen

https://m.youtube.com/watch?feature=yout...s6hpDr8fn4

------------------------------------------------------------------------
www.elbe.ee - MB performance parts.

hents99

03-07-2017, 04:17 AM #4

Here's hx35 on om606 g wagen

https://m.youtube.com/watch?feature=yout...s6hpDr8fn4

------------------------------------------------------------------------
www.elbe.ee - MB performance parts.

View a Printable Version

1 Vote(s) - 5 Average

Users browsing this thread:
1 Guest(s)

Users browsing this thread:
1 Guest(s)