OM 606 Deck Height

STD Tuning Engine OM 606 Deck Height

OM 606 Deck Height

OM 606 Deck Height

View a Printable Version

0 Vote(s) - 0 Average

zeeman

Holset

444

05-05-2020, 11:19 AM #1

I have a 606 block in the machine shop to be bored for new pistons. They just called and suggested that it needs to be surfaced to clean up the head gasket surface.
What is the allowed amount that can be taken off to be safe? If it is an issue we can always resize the rods to make up the difference.

zeeman

05-05-2020, 11:19 AM #1

I have a 606 block in the machine shop to be bored for new pistons. They just called and suggested that it needs to be surfaced to clean up the head gasket surface.
What is the allowed amount that can be taken off to be safe? If it is an issue we can always resize the rods to make up the difference.

barrote

Superturbo

1,627

05-06-2020, 11:32 AM #2

A lot... if needed. Just to clear a gasket .1mm sufice and u can use a stock gasket. But u should acess CR

FD,
Powered by tractor fuel

barrote

05-06-2020, 11:32 AM #2

A lot... if needed. Just to clear a gasket .1mm sufice and u can use a stock gasket. But u should acess CR

FD,
Powered by tractor fuel

zeeman

Holset

444

05-06-2020, 12:11 PM #3

barrote A lot... if needed. Just to clear a gasket .1mm sufice and u can use a stock gasket. But u should acess CR

Are there any thicker head gaskets available?

zeeman

05-06-2020, 12:11 PM #3

barrote A lot... if needed. Just to clear a gasket .1mm sufice and u can use a stock gasket. But u should acess CR

Are there any thicker head gaskets available?

AlanMcR

mind - blown

400

05-07-2020, 03:41 PM #4

A6060160520 Cylinder head gasket 1.85mm (vs. 1.65mm)

AlanMcR

05-07-2020, 03:41 PM #4

A6060160520 Cylinder head gasket 1.85mm (vs. 1.65mm)

View a Printable Version

0 Vote(s) - 0 Average

Users browsing this thread:
1 Guest(s)

Users browsing this thread:
1 Guest(s)